|
previous topic :: next topic |
| Author |
Message |
pkh
Since 27 Feb 2005
6549 Posts
Couve / Hood
Honored Founder
|
 Wed Mar 19, 08 9:17 am Measure your stick (er.. Lunacy) |
 |
|
I need to get the measurements for the screw pattern on the 08 Lunacy to see if the NSI pads would fit. Unfortunately its in my car in the Gorge right now. Was wondering if somebody who has one on hand could do a quick measurement for me (need the spacing.)
Here's the pads I am talking about, super comfy on my Hein board so I'd like to use them on my Lunacy as well:
http://www.northshoreinc.com/store/pc/viewPrd.asp?idcategory=13&idproduct=231 |
|
|
Kataku2k3
Since 14 Aug 2005
3754 Posts
PDX-LA
Videographer
|
| Wed Mar 19, 08 9:22 am |
|
|
6 3/16" is what I'm getting. The only thing I see that would suck a little is since those pads only have one hole per side, you're going to be sitting slightly closer to one of your rails... though you might be able to adjust your duck a bit going diagonal. haha!
Last edited by Kataku2k3 on Wed Mar 19, 08 9:30 am; edited 1 time in total |
|
|
Mark
Since 20 Jun 2005
3678 Posts
I need my fix because I'm a
Naishaholic
|
| Wed Mar 19, 08 9:27 am |
|
|
| Kataku2k3 wrote: | | 6 3/16" is what I'm getting. |
Sorry to hear about that  though Im told thats average
_________________
Cleverly disguised as an adult...
www.naishkites.com |
|
|
pkh
Since 27 Feb 2005
6549 Posts
Couve / Hood
Honored Founder
|
| Wed Mar 19, 08 9:28 am |
|
|
| Sweet! Looks like that will fit, how did I know you'd be the one Adam. haha |
|
|
Kataku2k3
Since 14 Aug 2005
3754 Posts
PDX-LA
Videographer
|
| Wed Mar 19, 08 9:30 am |
|
|
| Mark wrote: | | Kataku2k3 wrote: | | 6 3/16" is what I'm getting. |
Sorry to hear about that though Im told thats average |
haha, fuck you, Mark! j/k!
| pkh wrote: | | Sweet! Looks like that will fit, how did I know you'd be the one Adam. haha |
Probably because I'm very kind and helpful... and I don't do shit! |
|
|
Hein
Since 08 Mar 2005
1314 Posts
Possessed
|
| Wed Mar 19, 08 9:50 am |
|
|
| The sandwich mount version would allow you to use both stock screws and mounting location. You can get it in the same sizes and layup options as the production plate. |
|
|
|
