previous topic :: next topic |
Author |
Message |
cathy o.
Since 11 Aug 2014
84 Posts
|
Thu Jul 20, 17 4:38 pm Slider rope spreader bar |
|
|
I've been trying to decide on a solution for a slider rope bar for myself. I wear the xs Ion board short seat harness and like to ride toe side and 'surf style' in the swell. I'm small, under 30" waist and my current bar is 8".
I can't seem to find anything that small. The Cabrinha Fireball is too big. So are the Dynabars. Do I need to fashion something myself? Would a 10 or 11" bar work? Anyone using a setup for smaller waisted riders?
Appreciate your help and advice!
|
|
|
Da Yoda
Since 12 Mar 2009
79 Posts
|
|
|
Da Yoda
Since 12 Mar 2009
79 Posts
|
Thu Jul 20, 17 6:14 pm Re: Slider rope spreader bar |
|
|
cathy o. wrote: | I wear the xs Ion board short seat harness and like to ride toe side and 'surf style' in the swell. |
Curious... Does your harness have some metal loops welded to the spreader that allow the leg straps to attach through? If so, this may cause some challenges for you since this design feature is specific to this harnesses' functionality.
The current crop of aftermarket rope spreaders are for waist harnesses, so unless someone is making something specific for a seat, you most likely will have to make a DIY version.
|
|
|
ldhr
Since 21 Jul 2009
1487 Posts
Hood River
XTreme Poster
|
|
|
calikitesurfer
Since 03 Aug 2015
11 Posts
|
Thu Jul 20, 17 7:49 pm Chop and tie |
|
|
I took a dremel to the hook and then ran a rope through slit for the harness to connect to the spreader bar. Tied knots and you're good to go. Been running it like that for years without issue. There's enough room for the harness latch and a rope, first few times it's tight, but as the rope compresses it fits easier and easier.
_________________ Tim |
|
|
cathy o.
Since 11 Aug 2014
84 Posts
|
Thu Jul 20, 17 8:07 pm Re: Chop and tie |
|
|
calikitesurfer wrote: | I took a dremel to the hook and then ran a rope through slit for the harness to connect to the spreader bar. Tied knots and you're good to go. Been running it like that for years without issue. There's enough room for the harness latch and a rope, first few times it's tight, but as the rope compresses it fits easier and easier. |
Did you do this with an Ion seat harness?
|
|
|
cathy o.
Since 11 Aug 2014
84 Posts
|
Thu Jul 20, 17 8:09 pm Ion spreader bar picture |
|
|
I do have the special welded ends for the straps. I was able to attached the Cabrihna fireball spreader bar to these shorts.
|
|
IMG_0527.JPG |
|
|
|
calikitesurfer
Since 03 Aug 2015
11 Posts
|
Thu Jul 20, 17 8:14 pm Add a rope |
|
|
Looks like you could tie a rope through the large hexagons on each end. I have a buddy that didn't chop his hook and runs the rope next to the hook and he said the hook doesn't interfere, you just need to give the rope enough length to rise a few inches above the hook.
_________________ Tim |
|
|
|